Coal Tar Epoxy Topcoat

We are the dynamic, business-oriented organization, ranking among the utmost entities in exporting, manufacturing and supplying an Coal Tar Epoxy Topcoat in Vadodara, Gujarat, India.

Features:
Effective
Easy to apply
Balanced composition

Product Description: Two component air drying polyamide cured Coal Tar Epoxy Finishing paint.
Recommended use: Recommended as a top coat for maintenance coatings in ships, ice plants and marine environment and where ever protection from chemical and water is needed.

Physical Data:
Colour: Black
Finish: Glossy/semi glossy/matt
Solids by Volume: 483%
Theoretical Coverage 12 sq. meter / liter at recommended DFT of40
Flash Point Base: 23 degree C
Hardener: 23 degree C
Mixed: 23 degree C
Drying Characteristics: Surface dry: 20-30 minutes; hard dry: 24 hours; full cure: 7 days
(At 30 degree Celsius and 65% relative humidity)
Shelf Life: One year in sealed container

Application Data:
Mixing Ratio Base: 3 and Hardener : 1
Maturation Time: 30 minutes
Pot Life: 6 hours at 30 degree C
Application: By brush / air spray / airless spray
Thinner: AK - 579
Recommended DFT: 40 microns
Over coating Interval Min: 8 hours; Max: 24 hours
If exceeds, the surface should be roughened by emery scuffing
Compatibility: Can be applied over recommended epoxy and polyurethane primers, intermediate coats.

Resistance Guide:

Chemical Resistance

Exposure splash and spillages mild fumes/outdoor resistance
Acids: Good
Alkalies: Good
Solvents: Very good
Salt: Very good
Water: Very good

Temperature Resistance
Continuous: 93 degree C
Intermittent: 120 degree C
Weather ability: Very good with suitable top coat
Flexibility: Good

Surface Preparation: Remove grease, oil and other contaminants preferably using degreasing solvent. Blast clean to a minimum of SA 21/2 Swedish Standard SIS 05 5900 with a surface profile not exceeding 65 microns. If blasting is not possible, make full use of mechanical devices along with manual chipping and wire brushing to remove loose rust and scale to St. 2 Swedish Standard SIS 05 5900. Excessive burnishing of steel is to be avoided. Thoroughly dust down all surfaces.