Advance Stainless Steel Portable Electric Small Humidifier For Office, Home, Bedroom

Bullets:-
*Model :- AIHE150
*Colour :- Mirror Finish
*Material :- Stainless Steel
*Power Source :- Corded Electric
*Capacity :- 3-5 Ltrs./Hour
*1 Year warranty against any manufacturing defect

Technical Specification:-
*Evaporation :- 3-5 Litre/Hour
*Power Supply: 220-240 VAC/50 Hz
*Stainless Steel Body Operating Load :- 100 W
*Water Pressure 5PSI
*Water Capacity - 1.5 Litres
*Atomizing Capacity : 30-50 ml/min.
*Manual timer (Optional).
*Float Valve (Optional).Uniform distribution.

Product Description:-

Operation

1)WARNING: Designed for atomizing water only! Do not use flammable, toxic or corrosive liquids.
Operating the unit using the fogging head will provide directional fogging output and a drier fog.
For maximum fogging and circulation, operate unit without fogging head. Fog will propel 4 ~ 5 feet above the
unit.

2)WATER CONNECTION - Place the unit on a level surface, such as a bench top or floor. In an environment with little to no ventilation, place the unit in a central location. In a ventilated area, place unit near the intake end. When the unit is in the desired location, connect a water supply to the female inlet.
See options as follows:
Plumb directly to a water supply
Connect to a garden hose fitting.
Plumb to a storage tank higher than the fogging unit (gravity feed).

3)Power Connection - Plug the unit directly into an electrical outlet for evaluation. Listen for a smooth, quiet operation. Motor shaft
should be cantered and vertical. Make any necessary adjustments. If the power cord is damaged, it must be
Replaced, its service agent or similarly qualified persons .

4)No Fog: - Check for motor rotation. If motor is operating properly, there will be an adequate amount of water in the pan
(1/4 inch to 1-1/4 inch)
If the pan runs dry, the float valve may be sticking in the up position. If so, the inlet water pressure needs to be
Reduced. If water supply is adequate, check the tapered pump for internal calcium build-up. Remove, inspect and clean as needed.

5)Overflowing Pan: - An overfilled pan can cause poor quality fog and wetness around the unit.
A leaky float valve or a float that has filled with water may be the problem. To check the float, raise it out of the water and visually inspect it. No water should be inside and it should not sink.
If OK, then check for leaky valve. Turn water off and remove the fogger from the pan.
Empty the pan and towel dry. Hold the float in the up position and turn on the water.
If any water enters the pan while the float is in the up position, the float valve needs to be replaced.