Tile Fixing Adhesive In Gandhinagar

Hardening Time7 Days

Coverage3 Kg/m2

Layer Thickness3 mm

Water Consumption1.4 liters/5Kg

Tensile Adhesion550

Pot Life60 minutes

Product TypeTile Adhesive

Packaging20kg bag

ColorWhite

MaterialCement based

ApplicationInterior/Exterior

UsageFixing tiles and stones to various substrates

MOQ1 Unit/Units

MaterialMild Steel

Automatic GradeAutomatic

Control SystemPLC Control

Drive TypeElectric

Voltage220 Volt (v)

Capacity2.5 T/hr

MOQ10 Piece/Pieces

UsageConstruction

GradeIndustrial grade

ApplicationPlaster

Physical StatePowder

MOQ100 Kilograms/Kilograms

ColorBlack

UsageIndustrial

TypeAlumina Bond Tiles Fixing Adhesives

SizeDifferent Available

MaterialMetal

Product TypeAlumina Bond Tiles Fixing Adhesives

PackagingPouches

Weight250g

ColorRed

MaterialCement based

Setting time30 minutes

Coverage area1 sq m

ColorGray

MaterialCement based

Packaging20kg bag

FormPowder

ApplicationFlooring & wall

AdmixtureChemical

MaterialCement polymers

ColorGrey

Weight25 kg

PackagingKraft paper bag

ApplicationTiles marbles

FeaturesStrong adhesion Weatherproof Easy application Cost-effective Durable Versatile High performance

MOQ5 Pack/Packs

Adhesive Typesolvent adhesive

ColorWhite

UsageConstruction

ApplicationSpecially designed for interior & exterior floor and wall installation of all types of glass mosaic. Swimming pools various water body. It can be used to clad glass tiles and natural stones/ artificial stones.

Physical StatePowder

MOQ100 Bag/Bags

FormPowder

ColorWhite

UsageFootwear Leather

Physical StatePowder

ColorGray

MaterialPolymer based

FormPowder

AdherenceHigh

FlexibilityHigh

Water resistanceYes

MOQ4 bags Bag/Bags

ColorWhite

TypeGlass Mosaic Tile Adhesive

Physical FormPowder

Application1. Power should be applied with a suitable toothed spreader to be chosen according to the size andcharacteristics of the rear surface of the tiles. It is best to use the smooth part of the trowel to spreada fine initial layer pressing down hard so as to obtain maximum adhesion to the substrate and toregulate water absorption after which the thickness can be adjusted as required by tilting thespreader at an angle.2. Spread the adhesive over a surface area which will allow for laying of the covering materials within the indicated open time and check for suitability of the adhesive at regular intervals. The open time may vary considerably even during the application depending on various factors such as exposure to sunlight air currents absorbency of the substrate temperature and relative humidity of the atmosphere.3. Press down each tile to allow for complete uniform contact with the adhesive. In the case of laying in environments subject to heavy traffic in outdoor locations on underfloor heating systems or with materials4. In general ceramic tiles do not require preliminary treatment however these materials should be checked to ensure they are free from traces of residual dust or materials not properly anchored to the surface.

Chemical NameConstruction Chemical