Improved Bl Touch Adapter Board - Black | Compatible With Novo3d Fdm Printers, Plug-and-play Installation, No Wire Cutting Required

Adapter board is Improved design with wider power channels. With this adapter, no wires need to be cut!! Simply connect this between your board and your cable, attach the 3 BL touch wires and upgrade your firmware. The pin 27 board makes installing a BL touch or filament sensor fast and easy. Normally you would need to cut the ribbon cable and solder into the pin 27 but with the board its plug and play.(after firmware update) Make sure to check your wire configuration on your BL touch or filament sensor. The new BL touch sensors should plug right into the board without depinning the connector. Left to right: Brown-Ground, Red-5v, Yellow/Orange-Signal Disconnect LCD ribbon ext1 on the control board Connect Ext1 to the pin 27 board Connect BL touch to the 3 pins on the pin 27 board. Left to right: Brown-Ground, Red-5v, Yellow-Signal Connect the pin27 to the main board. Make sure to align the header pins from the pin 27 to the main board.