Automatic Conveyor Dryer - Polyester Thread Belts, 150-550 Kg/h Capacity | Fully Automated System, Integrated Humidity & Temperature Control, Energy Efficient Design

These chambers have a wide range of advantages in comparison with usual convection dryer chambers, which are used in tray drying. The production process is fully automated from the point when we have a raw product until it is ready for packaging. There is no necessity for manual load. Control and speed regulation of the belts, temperature, and humidity executing automatically at all stages of drying according to the set parameters
In the design and manufacture of the proposed equipment we used modern materials and components, as well as cutting-edge technology with the relevant international requirements. This conveyor dryer with belts made of polyester thread allows you to use your heat more wisely, without any unnecessary leaks. At the first pneumatic conveyer, the placer loads pasta on the belt where it heats up to 60-70 degrees and intensively removes moisture. Fans, which are set on the cover of the chamber, move humid air away from pasta, moving it along to the upper section, and directing it either into the outside drawing system or into the section of this convection dryer. There are softer conditions for drying in the bottom section, the temperature is lower and humidity runs up to 75 %, due to incoming air and steam which is fed by the steam generator. Electro-heaters are used as heating elements, but according to the additional agreement, it is possible to install the steam heater. Temperature and humidity control is provided with sensors set in each section.