Taximeter With Gps Printer

LCD Graphical display 128X64 pixels. Enables displaying Alphanumeric data as well as graphicalcontent on screen Capacitive Touch sensitive Keypad of 9 nos. of Keys with LED Illumination. No Mechanical wearand tear. Long life. LED backlit illumination for trouble free operation at night and low lightconditions. Found mostly in new Hi-end electronic equipments.GPS Module with internal Active Patch antenna suitable for receiving GPS data from satellites inUrban environment. A-GPS (Assisted GPS) support.GPRS Module Dual band Class 12 GPRS with internal PCB Antenna. External Antenna onRequest. Voice communication supported by providing Phone receiver Jack on Connector Panel.Auto configuration of APN. SMS can be used as secondary mode of data transmission if GPRSconnectivity not available.Receipt Printer Printing of Fare receipt after Trip End and Totalizer Values on 2 wide Thermalpaper roll. Paper not present indication. Transparent Paper holder clearly shows the quantity ofroll in the holder. Sliding cap over paper-out slot for Dust protection. Printing of customised Farereceipts using PC based Message configuration utility. Printing Font sizes 16X24 and 12X17.Reverse printing Underline in message printing.2USB Interface USB 2.0 FS device configuration for downloading Configuration files interfacingwith other USB Host devices e.g POS Machine.Micro SD Card MicroSD card for storing Metering logs and events GPS position data to displayaddress of location based on GPS data without accessing IP networks.CAN Bus Interface CAN bus external data interface. Our Remote Terminal accessory communicates with the Meterthrough CAN bus protocol. Remote Terminal can be configured as Master / Slave as per therequirement. If configured as Master Metering related keys / buttons in the Fare meter will bedisabled and Keys / buttons of the Remote terminal send commands to Fare Meter.Sensor Inputs Sensor Input from National make Adaptors/transducers for Autos and Taxiswith mechanical Odometers. Direct Pulse input from Taxis having electronic pulse Interface.Sensor Open and Sensor Short detection. Pulse Tamper detection.Additional Sensor Inputs Additional 3 nos. of sensor inputs provided for customizedapplications.Relay Outputs 4 nos. of Semiconductor relay outputs for Controlling Roof light signals likeHIRED VACANT and OFF DUTY. These Outputs are fault tolerant and any output driveparameters can be programmed as per the type of lamp connected.For Hire LED For Hire LED illuminated indication on the back side of Meter.Data Memory On-board data memory to store packet data in the absence of GPRS. Minimum15000 logs can be stored in the Meters data Memory.Alarms / Alerts Unit open tamper detection SIM card removed from SIM holder detectionPower removed from External Automotive battery detection Low level of Internal batterydetection External battery Low voltage or High voltage detection..Totalisers Shift daily and cumulative totalisers for no. of trips Paid Kilometers Total travelledkilometers paid fare paid waiting fare. Printing of Totaliser data.Battery Back-up Battery back-up for LCD Keypad GPS and GPRS during power disconnectionfrom Automotive battery. Back-up time 4hrs. with GPRS data transmission rate of 2 minutes.Back-up time vary based on GPRS data transmission rate.Housing Plastic ABS +PC with IP54 protection