Rebar Coating Chemical

Polyfix (Rebar Coating Chemical)

Polyfix is basically a polymer based coating that is specially formulated to protect steel from corrosion. Mild steel starts corroding when it is directly exposed to the atmosphere or when it comes in contact with water. Due to corrosion reduces the strength of steel making it unable to bear the designed loads. Therefore it is very important to prevent steel from corrosion.

Steel can be prevented from corrosion if conditions around steel are maintained in the alkaline range. Polyfix is alkaline in nature (pH above 9) and cement itself is alkaline in nature. Thus when this mixed slurry is applied on steel, it forms a permanent protective coating preventing any further corrosion.

Application Procedure

• First clean the steel surface of any loosely held particles, scales by a wire brush/ sand papers. Swipe down the surface with a paint brush /cloth again.
• Prepare slurry by mixing 1 Kg Polyfix and 1/1.5 Kg fresh cement into a lump free consistency. Add little water for painting consistency. Then apply this slurry on the surface by a paint brush. (paint stainer/cement colour can be added for desired colour)

Note:

• Prepare adequate amount of material which can be used in 30 minutes.

Packing : 5,25,50 kgs

The information given is true to the best of our knowledge. They are offered in good faith but without guarantee as conditions and methods of use of all our products are beyond our control. Users are requested to determine the suitability of our material before adopting them on a commercial scale