Handmade Anti Tracking Heat Shrink Sleeves

Our enterprise is run by a team of highly qualified personnel, who helps us to manufacture and supply an exclusive range of Anti Tracking Heat Shrink Sleeves. These sleeves are used in power stations, railways and telecom sectors for covering wires which are used for power distribution purpose. To manufacture the sleeves, we use optimum quality materials, sourced from the most reliable vendors. We precisely check the Anti Tracking Heat Shrink Sleeves on certain quality parameters before offering at the cost effective prices. Features: Completely shock proof Easy installation Can withstand any weather condition Anti Tracking Heat Shrinkable SleevesPEP 6000 is a highly upgraded polyolefin material with shrink ratio of 3:1 offering excellent electrical properties Physical & Chemical. PEP 6000 is suitable for wide range of applications, such as in power lines, transformers, MV joints, Terminators, Bus bars in indoor & outdoor applications. PEP 6000 is suitable for straight & bent bus bars. These are extremely flexible allowing easily positioned on bus bars and quickly installed using a gas torch. PEP 6000 Anti-Tracking tubes are having high expansion rate each size of tubing fits a range of bus bars. Main Features Continuous Operating Temperature range -40oC to+120oC Shrink Ratio : Upto 3:1 Dieletric strength : 30 kv/mm minimum Operating Voltage: Upto 36 Kv Available in continuous length or 1.2 mtr length. Unlimited shelf life Easy to installation high reliability Specifications Property Typical Permornce Tensile Strength at break 12 MPA minimum Ultimate Elongation at break 300% minimum Operating Temperature -40o C to +120 oC Minimum Shrink Temperature 120oC Specific Gravity 1.25 Dielectric Strength 30 kv/mm Heat Shock No dripping, flowing or cracking Heat ageing Tensile Strength Min. 70% of the value of unaged specimens Elongation Low Temperature Flexibility No cracking at -55oC Water Absorption 0.5% Hardness 40 shore D Volume Resistivity 1 x 1012 ohm-cm Dielectric Constant 5 (max) ERT No failure by tracking or erosion after 1 hr at 2.5 Kv Fungus Resistance Chemical Resistance Good Weathering Resistance Good Specifications Catalogue Number Bus Bars Dimensions Anti-Tracking Tube Dia Meter Wall Thickness Fully Recovered Flat WIdth SquareEach Size Round DIA Meter AS Supplied AS Fully Recovered Max Min PEP 20/8 - A/T 12 - 16 10 20 8 1.5 PEP 30/10 - A/T 25 - 24 16 30 10 2.5 PEP 45/17 - A/T 35 25 34 24 42 17 3.0 PEP 60/25 - A/T 45 30 42 30 60 25 3.2 PEP 80/30 - A/T 50 35 50 35 80 30 3.4 PEP 100/35- A/T 75 40 70 60 100 35 3.6 PEP 120/45- A/T 75 50 80 65 120 45 3.8 Standard Colour : Brick Red Installation : When heated above 120oC P.E.P 6000 will shrink unrestricted to a minimum 50% of its supplied diameter and fits on object perfectly. Packing : Available in spools of continuous length or 1.2 mtr length. Ordering Information : Refer to dimensional table and select the size which will shrink snugly over the component to be covered. If recovery is restricted the resultant wall thickness will be less than specified , for detailed information contact our executives.