Automatic Punching Press Bottom Dead Point Monitoring Device

This Automatic Punching Press Bottom Dead Point Monitoring Device will detect the slugs coming up by detecting the displacement of stripper plate when slugs come up. The displacement is detected by the sensors, which are installed on the stripper plate.
Monitoring accuracy : +/-1I m
Achieved a low price.
Quick replacement is achieved by interchangeability of sensor.
Timing sensor is not required since it has internal synchronization.
Digital type achieved simple operation. (There is no variation in operator.)

SPECIFICATIONS :
Designation & Type NEW SELBER V RM-1310
Sensor principle Eddy current loss type, Proximity sensor RS-833H
Displacement indication +/- 99I m LED 2 digits (1I m/digit, +/- indication)
Monitor value indication 99I m LED 2 digits (1I m/digit)
Monitoring resolution +/-1I m
Repeatability Less than 1I m
Reaction to abnormality Error lamp turns on and output the stop signal
Response speed Less than 12msec to output the stop signal
Power consumption AC100 - 230V, 50/60Hz, Less than 8VA
Circum. temperature 0-50degrees
Max. SPM 30-3000min-1(spm)
Sensor setting distance 1.2 +/-0.3mm
Output "Stop output" Relay contact (A, B contact) AC, 250V 2A
Input "Reset input", "Start input", No-voltage contact or NPN open collector
Cable length Proximity sensor : 10cm, Connection cable : 3m
Dimensions 110 (W) X 50 (H) X 120 (D) mm
(Excluding projections and fixing angles.)