600w Wind Charge Controller For 12v/24v Wind Turbine Generator

Our offered 600W Wind Charge Controller For 12V/24v Wind Turbine Generator allows you to fully charge your batteries and then make use of the extra power. This form of regulation is required for wind turbines to always keep a load on the generator to prevent over-speeding. This microprocessor controlled charge/diversion regulator offers two charging modes, cycling mode for frequent use and non-cycling for stand-by power. Charging and discharging voltage levels can be default or user set. An optional fan may be connected that will be switched on while charging to remove any explosive gas from the battery enclosure. A relay protection feature prevents rapid, destructive switching of the relay. A heavy load setting bypasses cycling and the relay protection feature to allow quick response to accommodate heavy loads.

Features:-
* High quality technical components guarantee its stability and reliability
* This charger is designed with a sound protection system
* Anti-water, anti-dust shell makes it applicable in various outdoor environment
* Voltage/current control charging make sure storage batteries are always at the best state of charge.
* MPPT charging effectively collects power from generator to charge storage batteries.
* Using PWM to unload redundant electrical energy, thus to protect batteries and make sure safety of generator
* It give preference to wind power supply, when wind power is not enough, it can switch to utility power supply if needed.