OIL SOLUBLE DEMULSIFIER

• GUJCHEM
  OSD is a totally organic liquid formulation of surfactants and
  dispersants in a water and soluble in toluene ,Xylene, Aromatic
  solvent, crude oil for the demulsification of water in oil and oil in
  water.
  
  
  
  
• GUJCHEM
  OSD capable of performance at room temperature, but with improved speed
  and percentage of oil removed when applied at temperatures near 60 deg.
  C (140 deg. F).
  
  
  
  
• GUJCHEM
  OSD destabilizes the oil-water interface that surrounds each water
  particle in the emulsion, replaces the emulsifier molecules(if any),
  and allows the water to coalesce.
  
  
  
  
• GUJCHEM
  OSD is a completely combustible, non-abrasive, non-ash-forming
  treatment which will improve the quality of the fuel it is added too.

CHARACTERISTICS :

ADVANTAGES :



Does not stay with the water phase, therefore does not contribute to water pollution

Stays with the fuel and actually improves burning characteristics of the fuel

Uses lower dosages than most competing products

DOSAGE :



Because
of the diverse nature of oil and waste amenable to treatment with
GUJCHEM OSD, specific recommendations have to be made on a case-by-case
basis. The dosage of GUJCHEM OSD prescribed to break a particular
emulsion varies from as little as 1 gallon per 20,000 gallons (50 ppm)
of oil to as much as 1 gallon per 10,000 gallons (100 ppm) of oil. A
few clients have even found that 20 ppm was more effective than the
higher dosages, so we suggest adding the lower levels to your
laboratory bench tests to verify the correct dosage for the specific
application. Finding the most cost-effective dosage, as well as
determining the best conditions of temperature, slow mixing, settling
time, etc., is best done in the laboratory, using a sample of the
actual oil or waste and a sample of GUJCHEM OSD

APPLICATION :



Once
you have determined the correct dose of GUJCHEM OSD, fill the tank with
the waste-oil-water solution and inject the correct dose of GUJCHEM OSD
directly from the drum. Mix thoroughly, with the assistance of a pump,
for two to five hours. Mixing time varies depending on the size of the
tank and the speed of the motor. Allow the fuel to settle and check for
water separation. Depending on the configuration of the tank, either
remove the water by means of a drain in the bottom or suck the clean
oil off from the top of the tank.



PACKAGING AND HANDLING :



GUJCHEM
OSD is packaged in 55 gallon mild steel drums (208 liters) It contains
a h aromatic solvent, and should be handled easily semi skilled workers.

Note: Above
Gujchem Range are the running products. We can produce higher moles
on customer specific demand and specifications can be altered as per
customer requirement.