Membrane Filter Plates - Polypropylene & Synthetic Rubber, Up To 30 Bar Inflated Pressure For Enhanced Dewatering Efficiency

During the initial phase of the filtration cycle, so-called a fill and filtrationa the process is similar to the chamber Filter Press. After reaching a predefined pressure, usually around 4-10 bar, depending on the sludge characteristics, sludge feeding is stopped and the membranes slowly inflated, using either water or air as squeeze medium. The cake is hereby compressed and dewatered further. This process is continued until the filtrate flow reaches a preset minimum limit. Then the squeeze medium is relieved and the cake discharged.

Membrane Filter Plates are designed just like the previously described chamber plates. A flexible membrane is fixed to the support body. Materials for the membranes include Polypropylene, synthetic rubber (for example NBR, EPDM) or thermoplastic elastomer (TPE). Special materials such as PVDF are also available. The membrane is impermeable and serves to compress the cake within the chamber after the filtration process is complete. Liquid or gas (compressed-air) can be used as membrane inflation media. In order to guarantee maximum protection for the membrane filter press, we use special safety systems for the various membrane inflation media. Inflation pressures up to 30 bar, and in special cases even higher, are possible.