Mv Cables In Mumbai

MOQ1 Piece/Pieces

Usage & ApplicationsCable entry into junction boxes, connection boxes, panels, bulkheads and enclosures

Install TypeHot-air gun or propane torch; heat from the cable side, not on the nut

Operating Temperature-40 to +110 deg C (continuous)

Tensile Strength12 N/mm2 min (ASTM D638)

Product TypeHeat-shrinkable cable gland / cable entry seal, single outlet

Rated Voltage600 V (Gala catalogue rating)

MOQ1 Piece/Pieces

Coating TypeHeat Shrinkable or Cold Shrinkable

Install TypeCrimp ferrules, then heat shrink with a gas torch; illustrated instructions in every kit

Installation GuidelineFollow manufactureraEURtms instructions; ensure cables are clean, dry, and free of contaminants before jointing

StandardIEC 60502-4 (VEIKI-VNL, Hungary, 2023, certificate 13222/VNL); IS 13573-2 and IEC 60502-4 (KEMA Type Test Certificates 1037-15 and 1038-15, 2015, 11 kV three-core joint, 3 x 185 sq mm Al XLPE)

Density1.6 Gram per cubic centimeter(g/cm3)

FeatureMoisture proof, Flame retardant, Anti-corrosive, High insulation

FeaturesWeatherproof, Easy Install, Cost-effective, Durable, Corrosion resistant, Environmentally friendly, High performance, Reliable, Safe, Long lasting

FeaturesHigh voltage, Corrosion resistant, Weatherproof, Low maintenance, Durable, Safe operation, Reliable performance, Long lifespan

MOQ1 Piece/Pieces

Install TypePush on by hand; no tools or heat

Thermal ConductivityLow thermal conductivity

Installation GuidelineSlide over cable end and heat for proper fit

Surface TreatmentSmooth surface finish

LayerSingle layer

Usage & ApplicationsTemporary protection of cable ends, pipe ends, tube ends and parts against weather, moisture and contamination

Tensile Strength12 N/mm2 min (ASTM D638)

Operating Temperature-40 to +100 deg C (continuous)

Install TypeShrunk over the outer sheath with a gas torch

Usage & ApplicationsSealing both ends of HV and EHV cable drums while venting evolved gas

Product TypeHeat-shrinkable cable end cap with non-return pressure relief valve

MaterialCross-linked polyolefin cap; brass-and-steel valve

FeaturesHigh-temperature, Water-resistant, Non-shrinkable, Easy application, Durable, Corrosion resistant, Weatherproof, Conformable, Heat resistant

MOQ1 Piece/Pieces

Install TypeWrap, close the overlap, shrink with a gas torch from the centre outwards until adhesive appears at the ends

Usage & ApplicationsRepair of damaged cable sheaths and protection of existing connections without cutting the cable

Product TypeHeat shrink cable repair sleeve, wraparound, adhesive lined

MaterialCross-linked polyolefin backing with hot-melt adhesive layer

ColorBlack

Size9 sizes, GMRS-19 to GMRS-250, for cable OD 5 to 192 mm

MOQ1 Piece/Pieces

Operating Temperature-20 to +90 degC (service temperature, Gala typical value, black and red)

Install TypeCold applied; peel off the liner and press or wrap into place

Usage & ApplicationsWater sealing and void filling in heat shrink cable joints and terminations, lugs, breakouts and connectors; telecom sealing (black)

Product TypeMastic sealing tape (cold-applied), strips and rolls

MaterialButyl rubber based mastic sealant on silicone-coated paper liner

ColorBlack (HBMT), red (HRMT), yellow (HSCM)

MOQ1 Piece/Pieces

Install TypePropane or butane torch, closed end first

Usage & ApplicationsSealing and identifying cable drum ends for cable-length warranty control

Operating Temperature-40 to +100 deg C (continuous)

Product TypeHeat-shrink cable end cap with customer logo printing (tamper-evident)

MaterialCross-linked polyolefin

ColorBlack, with printed marking

MOQ1 Piece/Pieces

Install TypeUsually factory fitted; site fitting with propane or butane torch

Usage & ApplicationsPulling power and telecom cables into ducts and trenches while sealing the cable end

Product TypeHeat-shrinkable cable end cap with steel pulling eye

ColorBlack

MaterialCross-linked polyolefin cap, steel pulling eye

SizeGEC 301L-PE to GEC 701L-PE, cable outside diameter 28 to 112 mm

MOQ100 Piece/Pieces

Install TypeWound over the earth braid on the screen or armour by hand; no soldering

Usage & ApplicationsClamping earth braids or wires onto cable screens and armour in MV joints and terminations

Product TypeConstant force (roll) spring for solderless earth connections on cable screens and armour

MaterialStainless steel (per Gala sheet)

FeaturesReusable, Insulated, Durable, Weatherproof, Corrosion resistant, Easy installation, Cost effective, Reduced downtime

MOQ1 Piece/Pieces

Install TypeScrewdriver or nut driver; adjustable and re-usable

Usage & ApplicationsClamping components and connections in cable splice and jointing assemblies; general hose and duct clamping

Product TypeWorm-drive band clamp with captive screw

MaterialStainless steel, or steel electroplated for corrosion resistance

MOQ50 Meter

Conductor TypeStranded

DiameterBased on size; typical outer diameter varies with specification

Armored MaterialUnarmoured/Armed with steel wire or tape (as specified)

FeaturesHigh strength, weather resistant, UV resistant, flame retardant, excellent electrical conductivity

Core NumberSingle core or Multi-core

InsulationXLPE / HDPE as per design & voltage rating