White Cement Based Wall Putty - Optimum Quality, Matte Finish, Heat Resistant | Long Shelf Life, Effective, Pure

Long shelf life

Purity

Effectiveness

Heat resistance

Scrap the previously painted surface by brushing it to remove loose or flaky material and paint, dust, grease, dirt or powdery material.

Growth of algae, fungus or moss and chalking should be removed with the use of wire brush and cleaned with water. Treat the infected surface with a mild solution of household bleaching powder (recommended proportion- 2kg to 50 liters of water), and leave it on for 24 hours. Follow it up with washing the surface with clean water. The surface should be clean, dry and free from efflorescence.

The bigger cracks should be filled using cement and sand mixture in the ratio of 2:3.

Preparation of Orbit Wall Putty paste

Take required quantity of Orbit Wall Putty in a pan. 35-40% water by volume is required to prepare paste of good consistency.

Mix half of required water quantity into it. Knead/Mix the Putty & wait for few minutes.

Mix remaining quantity of water to get desired consistency.

Mix vigorously for 5-10 minutes for making a lump-free and uniform paste.

Mix the product in such quantities that it should be used within 2 hours of preparation.

Mixing may be done manually or by using a suitable electric mixer.

Ensure that surface is totally clean

Ensure that surface plastered or made with cementitious material.

The surface should be moderately rough and in just-wet condition.

Apply 1st coat of Orbit Wall Putty (1.5 mm thickness) using a blade / spatula on the wall with a "bottom to up" configuration

Apply 2nd coat of Orbit Wall Putty (1.0 mm thickness) preferably after 4 hours in summers and after 12 hours in winters. Second coat shall be applied "horizontally" to even out application marks of 1st coat, if any.

Remove putty paste again for 1 minute, if it is left undisturbed for 30 minutes.

Allow complete drying for 3 days and then use a fine emery paper to remove application marks, if any.