Waterproof Membrane Coating

Waterproof Membrane Coating

With the help of highly skilled manpower, we are instrumental in offering Waterproof Membrane Coating. Appreciated for their high elasticity, long service life and fuel and fire resistance property, these coating service highly demanded among clients. We render Waterproof Membrane Coating for swimming pools, basements, water tanks and other areas. To provide flawless coating services, we stringently check entire business operation. Moreover, we are committed to offer membrane coating services to clients within stipulated time period.

Further details:

Description

SAVE- IT 206 is a ready to use highly flexible, bitumen based, protective and waterproof coating. It is a high performance coating that dries to a tough, impermeable waterproof membrane.

Primary Use

Advantages

Technical Data/Typical Properties

SPECIFIC GRAVITY : 1 to 1.05,

SOLIDS CONTENT BY WEIGH : 62.5%

COLOR : Black

FLASH POINT : 1150 C.

TENSILE STRENGTH : 230 psi [ultimate strength can be increased up to 3 times by

fibre reinforcement]

TENSILE SET RECOVERY : 95%

WATER PERMEABILITY : Confirms the norms of IS : 2645

SOFTENING POINT : Up to 100 deg. Cent. If exposed to direct sunlight.

ADHESION TO MORTAR : 2700 n/m

LOW TEMP. FLEXIBILITY : No cracks

ELONGATION % :200%

Application Instructions

Surface Preparations

The application surface must be clean and free from dust grease and loose particles. Surface may be damp but not saturated.

Application

Apply one coat of SAVE- IT 201, universal deep impregnating primer, on well-prepared surface. SAVE- IT 206 should be stirred well before use. It is recommended that aminimum of 2 coats should be applied depending upon the degree of protection required after the primer coat. SAVE- IT 206 can be applied by brush, roller or sprayer. Successive coats of SAVE- IT 206 should be applied after a minimum of 3-4 hours of the previous applied coat. SAVE- IT 206 could be diluted up to 15-25 % for base and top coats to make the material workable and get the desired coverage.

Limitations

SAVE- IT 206 is not resistant to rain until the film has dried. This may take less than 45 minutes in hot dry climates and up to 12 hours in temperate humid conditions. Generally the product should not be applied in rain or if rain is forecast. Similarly, SAVE- IT 206 will freeze in its wet state so should not be applied to frozen substrates or when the temperature is below 5A A Aca A A a A A C or likely to fall during application.

Coverage

CONCRETE SURFACE : 3-4 Sq Mtr/kg/coat (Depending on the porosity of the surface)

Cleaning

Tools and equipments can be cleaned with pure water.

Packaging

SAVE- IT 206 is available in 10, 25, 50, 100 and 200 kg drums.

Storage

Store under cover, out of direct sunlight and protect from extremes of temperature. Failure to comply with the recommended storage conditions may result in premature deterioration of the product or packaging..

Whilst any information contained herein is true, accurate and represents our best knowledge and experience, no warranty is given or implied with any recommendations made by us, our representatives or distributors, as the conditions of use and the competence of any labour involved in the application are beyond our control.