Induction Heater 2001

Induction Heater 2001PRECISION Induction Heater - Series PIH - is designed to heat the Bearings and other shrink-fit components prior to mounting using latest technology intelligent micro controller based electronic controls. The life of Bearings and other torque transmitting steel components, which are shrunk-fit on shaft, may get cut short due to rough handling and faulty installation or mounting methods. This can be avoided by expanding them by induction heating for the purpose of mounting of the component. PRECISION Induction Heaters - Series PIH - are available in 5 different models for mounting, range of bearings having bore size from 14 mm and above. Fast, safe and economical heating of bearings is best features of PIH Induction heaters. PIH series is light weight and portable for better performance. It has power capacity of 3.5 / 4.0 KVA. The controls are intelligent micro controller based programmable electronic controls. It has two operating modes, Temperature mode and Time mode. Both are controlled through feather touch key Board. Both modes can be seen at the time of operation. It can also be used to heat bearings of larger diameter using a pair of Raiser Blocks size 55 x 55 x 125 mm. The unit can also be used to heat a plate of any magnetic material by placing the plate in place of the horizontal yoke across the vertical supports. FEATURES: Can be used for Mounting 8. Dismounting of inner RaceSafe, Reliable & Clean Process.Unskilled labour can be trained to operate.High Heating can be easily achieved.Lower cost 8. high efficiency.Precise Temperature and Time controls.Intelligent micro control based electronic controls  TECHNICAL SPECIFICATION PRODUCT DATA PHI 2001 Diameter (mm) Bearing 20 to 300 Bearing Weight 32 kg Power 3.5 / 4.0 KVA Voltage 230 V Power Control 25%, 50%, 75%, & 100% Temperature Control (Range) 0-250C Maximum Temperature 400C Accuracy Temperature 3C Time Control 0-99 Minutes Residual Magnetism <2A/cm Overall Dimension (WxDxH)(mm) 300 x 270 x 355 Space between Supports (WxH)(mm) 130x155 Weight (Mian Unit) 28kg Weight With Standard Yokes 37kg Horizontal Yoke Size (mm) 20x20x250 30x30x250 50x50x250 Can Heat Sealed & Pre-greased Bearings yes Thermal Ovar Protection yes OPTIONAL ACCESSORIES Horizontal Yoke Size (mm) 10x10x250 14x14x250 40x40x250 55x55x250 Digital Thermometer (0-500c) yes Roll-Sliding Model yes Swing Arm Model yes Riser Block (pair)(mm) yes Magnetic Temperature Prabe yes Equipment Trolley yes