Heavy Duty Soft Starter - 200-600v Input Power Supply, 32-bit Risc Processor Control Board | Dual Display Keypad, Integral Bypass Contactor, Adjustable Ramps

We are best-known Exporter, Manufacturer & Supplier of Heavy Duty Soft Starter in Mumbai, Maharashtra, India. The SSW06 is WEGa s third generation Soft Starter line. The keypad, with dual display, has red LED digits which provide visibility and make programming easier. Integral bypass contacts eliminate heat dissipation once the motor is at full voltage, which makes it extremely compact and allows for simple integration into non ventilated enclosures and replacement of electro-mechanical starters in Motor Control Centers. The SSW06 includes the following features:

200 - 600V, 50/60Hz input power supply

Built-in run rated (AC1) bypass contactor*

Duty cycle: 300% full load amps for 30 seconds, 10 starts per hour

Voltage ramp or current limit start modes

Detachable keypad with dual display (LCD and LED) and copy function

90 - 250Vac auxiliary control voltage

Single 32 bit RISC processor based control board

IP00 protected chassis enclosure

Six isolated 24Vdc programmable digital inputs

Three programmable relay outputs (2 Amp - 250V)

One 0 - 10Vdc programmable analog output

One 4 - 20mA programmable analog output

Motor PTC thermistor input

RS-232 serial interface

Adjustable acceleration and deceleration ramps (1 - 299 seconds)

Adjustable pedestal voltage (25 - 90% of line voltage)

Diagnostic features: Motor overload, over current and phase loss, motor immediate over and under current, SCR over temperature and fault, line phase loss and phase sequence, line over and under voltage

Display readings: Motor current, voltage, kW and power factor, line voltage and frequency, four last fault trips, run and power-up timers

Ambient: 32A F (0A C) to 131A F (55A C), 3300 ft (1000m) altitude, 90% non-condensing humidity

The SSW06 is WEGa s third generation Soft Starter line. The keypad, with dual display, has red LED digits which provide visibility and make programming easier. Integral bypass contacts eliminate heat dissipation once the motor is at full voltage, which makes it extremely compact and allows for simple integration into non ventilated enclosures and replacement of electro-mechanical starters in Motor Control Centers. The SSW06 includes the following features:

200 - 600V, 50/60Hz input power supply

Built-in run rated (AC1) bypass contactor*

Duty cycle: 300% full load amps for 30 seconds, 10 starts per hour

Voltage ramp or current limit start modes

Detachable keypad with dual display (LCD and LED) and copy function

90 - 250Vac auxiliary control voltage

Single 32 bit RISC processor based control board

IP00 protected chassis enclosure

Six isolated 24Vdc programmable digital inputs

Three programmable relay outputs (2 Amp - 250V)

One 0 - 10Vdc programmable analog output

One 4 - 20mA programmable analog output

Motor PTC thermistor input

RS-232 serial interface

Adjustable acceleration and deceleration ramps (1 - 299 seconds)

Adjustable pedestal voltage (25 - 90% of line voltage)

Diagnostic features: Motor overload, over current and phase loss, motor immediate over and under current, SCR over temperature and fault, line phase loss and phase sequence, line over and under voltage

Display readings: Motor current, voltage, kW and power factor, line voltage and frequency, four last fault trips, run and power-up timers

Ambient: 32A F (0A C) to 131A F (55A C), 3300 ft (1000m) altitude, 90% non-condensing humidity.