Fire Alarm System - 2 Zone And 4 Zone Control Panels | Features Conventional Smoke And Heat Detectors, Manual Call Points, Remote Response Indicators, Integrated Hooter

Main Control Panel - The Main Control Panel is the brain of the system. All the detectors are connected to the panel via wired loops. The looping is such that if any detectors fault out - the main panel will give a loop open or short signal. This enables one to know immediately when the Fire Alarm System is not functioning correctly. There are two type of Panel available - 2 Zone Panel and 4 Zone Panel.

Conventional Smoke Detector - The smoke detector, is manufactured according to UL 268 Standards, it senses the presence of smoke and warns you before the fire starts. These are mounted on ceilings and sometimes even above the ceiling for specific requirements. When it detects smoke an alarm gets generated through the hooter.

Conventional Heat Detector - The EN-54 approved conventional heat detector is designed with the state of the art combination of "Rate-of-Rise" and "Fixed-Temperature" operation ensures the best quality of heat detection in all environments.

Manual Call Point - Ideally placed at entrance/exit points, this is a manual alarm. When some spots a fir or smoke, one can break the glass cover of the Manual Call Point and an alarm is generated.

Response Indicator - A response indicator is device that gives remote visual indication of the fire alarm going off, if the detectors are placed in areas that are not visible easily.

Hooter - The hooter is separately connected the control panel. When a detector goes into an alarm condition, it communicates with the main