Electrical Panel Installation Service - Durable Zinc Electroplated Fasteners, 1800mm Optimal Mount Height, Comprehensive Compliance With Standards

About Electrical Panel Installation Service:-

To make sure that the entire installation is in conformance and in accordance with the design intent of the project for the Electrical and Low Voltage System in addition to the specification and as per approved shop drawings and comply.
with local and International Standards.
All the switchboards shall be fabricated at the manufacturera s works.
Before beginning installation in any area, examine all parts of the adjoining works into which applicable work is to be placed. Should any condition be found which will prevent the proper execution of the work, installation shall not proceed in that area until such conditions are corrected by the us.
Fix all equipment independently of wiring system. Use cadmium of zinc electroplated bolts, nuts, washers and screw.
Mount single DB at 1800mm from finish floor level to top of equipment, unless shown otherwise on drawing / schedules.
Ensures that clearance in front of switchgear is not less than 1m, or as indicated.
Number terminals, cables and component parts to correspond with manufacturer have certified drawings.
Terminate PVC, SWA PVC and MICS cables inside enclosure by securing cables to switchboards with gland bracket; and enclosure with glanding plates or fabricated steel extension boxes.
For flush installation, DBa s all conductors shall terminate behind the board in an adaptable box. For surface mounting, trunking shall be fixed between the board and ceiling or floor level, or conduit run directly into Trunking which prevent correct installation of the Trunking lid. Adequate earth continuity shall be made between the various components.