Disc Springs - 17/7ph, 304, 50crv4 Materials , High Energy Storage Capacity, Long Service Life, Low Maintenance Needs

Disc springs are conical shaped washers, designed to be loaded in the axial direction F only. They can be statically loaded, either continuously or intermittently, or cyclically deflected i.e. dynamically loaded.

Infinitely variable spring characteristics can be achieved by the arrangement of disc springs into stacked columns.

Introduction
Disc Springs offer a well developed solution to many engineering problems, which are loaded in the axial direction. Disc Springs are conically formed measured by angle in Discs through a equal combination of high force in a small space. Computerized design programmed to assist our customers for their specified applications. Disc Springs can be used as single disc or arranged in stacks. A spring stack can consist of either parallel spring or single spring sets. Disc Springs are obtainable with or without contact flats. Disc Springs and most Belleville Washers are manufactured to DIN 2093 AND DIN 6796. Disc springs are manufactured material are 17/7PH, 304, 50CrV4, Inconel X750,600,718 as per customer requirement . This systematic procedure of heat treatment is especially effective for springs as it gives the maximum dearness and therefore considerable hard wearing durable.
Adv:
Long Service Life.
Space Saving.
No Deformation or extreme tiredness under normal loads.
Low Maintenance cost.
High Energy Storage Capacity
Disc Springs
Spring Steel 0.20 to 16 mm wire diameter
Material Customize As per Partya s Requirement