Digital Wire Processor

These Digital Wire Processor cuts and strip various types of wires. With the five-line blade and a pair of discharge rollers, the KM-702N will bring you a successful result. Various sensors and operator friendly set-up with graphics are standard. In addition, special blade for flat cable can be installed as an optional choice.
a Equipment supplied with machine
- Graphic display for easy set-up
- Push button set-up of all machine function
- Auto Knife sensing for stripping blade set-up
- Up to 100 recipes for saving of standard set-ups
- Count of pieces needed
- Total pieces run
- Short mode for wires less than 35mm long
a Set-up of optional collection equipment and optional wire twister
a Single-step cycle
a Reverse button for removing wire form machine / Forward button for feeding wire through the guide tubes
a Cut button for testing cutting of material
a Emergency stop button on panel
a Five line knife set-up
a Dual rollers for accurate feeding of material
a Automatic lifting of discharge rollers during feed cycle to prevent damage to wire
a Wire run-out and/or tangle detectors
a Roller gap adjustment for various size wires
a Five wire guide tube(Three guide pipes on KM-703N)
a Insulation slug blow-off for slug removal during cycling
a Filter/regulator/lubricator for pneumatic system
a Ownera s manual