Computerized Mechanical Heat Pump Test Rig - Stainless Steel Skid Mounted Frame, 372w Compressor Capacity, Touch Screen Display | Remote Data Acquisition, Automatic Operations, Performance Monitoring

Heat pump operation management controller supplied with programming software and cable. The program is provided on computerised DAQ. Sensor Set to include
1) Thermocouple temperature sensor for measuring temperature in particular:-
a) Compressor input
b) Compressor output
c) Reducer inlet
d) Water inlet exchanger
e) Water outlet exchanger
2) 2 analog pressure transmitters (high and low pressure)
3) 1 water flow meter on the impulse output condenser All the data of temperature, pressure and flow, as well as the power consumed, the power restored and the
efficiency of the pump can be visualized on the panel display.
Total Equipment is skid mounted in SS 40 x40 Frame Structure with Castor
wheels. All wetted parts also made of SS-304
Compressor Capacity: 372W at 7,2/32C Coaxial coil heat exchanger (condenser) Refrigerant content: 0,55L
Water content: 0,3L
Finned tube evaporator Transfer area: approx. 0,175m2
Pump
Max. Flow rate: 1,9m3/h
Max. Head: 1,4m
Hot water tank volume: approx. 4,5L Refrigerant: R134a/22/A
Filling volume: 1kg
CO2-equivalent: 0,6t
Measuring ranges
Pressure: 2x -1-15bar
Temperature: 4x 0-100C, 2x -100-100C Power: 0-6000W
Flow rate: 0-108L/h (water)
Flow rate: 10-160L/h (cooling water) Required for operation
230V, 50Hz, 1 phase
Touch screen based Fully automatic system with password protection
Data acquisition should be Remotely operated by Smart phone, Tablets, PC, laptops via Ethernet and Wi-fi Should be equipped with all safety protections Flow visualization should be available in the DAQ System
Should be equipped with both manual and auto operation
Power consumption of individual system, all sensors data should be display and logged automatically
System should have software for operating, data logging, processing and data displaying
Performance variables (e.g., Heating/Cooling COP, Heating / Cooling load etc.)
should be automatically calculated and displayed and should be stored in pen drive also along with PC.
Instruments should be provided with 3D drawing of complete equipment along with the name and make of all standard components used in the test rig
Each rig should have small aesthetically appealing poster with schematic diagram and basic working detail