Bogner Hardner - Synthetic Resin Cross Linking Agent, 3-7% Mix Ratio | Adhesive Accelerator

The adhesive either of natural, synthetic rubber or polyurethane is to be mixed with the cross linking agent BOGNER HARDNER. The percentage of cross linking agent to adhesive can vary from 3 to 7% depending on the end use. Generally 5% is recommended. The adhesive mixed with the cross linking agent is to be brushed on the roughened surfaces of both the substrates to be joined. In case of bonding of PVC, the surface is to be wiped with BOGNER-CL-300

The adhesive-coated surface is to be kept open for solvent evaporation and then bonded as per recommended process.
For bonding metal with compound rubber, the metal surface is to be sand blasted or acid etched followed by degreasing with BOGNER-CL-300. Thin and uniform layer of BOGNER HARDNER-500 is to be brushed on the clear and dry metal surface. Allow to dry for 20-30 minutes. Lay the compounded unvulcanized rubber on the coated metal and vulcanize the rubber in mould under heat and pressure as required.

Caution Highly inflammable. Replace lid immediately after partial use. Store in a cool and dry place.
Packing 500 gms, 250 gms .100gms.