Bitumen Emulsion

Introduction Of Bitumen Emulsion:- Minute Bitumen particles dispersed in water is called Bitumen Emulsion. An Emulsion in which the cation of the emulsifier is at the interface with the bitumen particle: An Emulsion in which the particles are positively charged and the aqueous phase is acidic are called Cationic Emulsions. UNIVERSAL Cationic Emulsions are manufactured and tested confirming to the specifications of IS 8887. UNIVERSAL Bitumen Emulsion have advantages over hot applied bitumen. Cold applied Bitumen Emulsions is fulfilling a real technical and commercial requirement for roads. Bitumen Emulsions are used in road works due the reliability, economy and simplicity of application. Type of  Bitumen Emulsions:- UNIVERSAL Cationic Emulsions are broadly classified in three types. Rapid Setting Type RS Medium Setting Type MS Slow Setting Type SS All above types are as per specifications of IS 8887 the latest edition. The physical and chemical specifications are as shown in table. The product is fluid enough to be applied at normal temperature without heating. They remain fluid after application for giving sufficient time for easy application.Typical Uses:- The recommended uses of the UNIVERSAL Cationic type Emulsions are as below:Rapid Settings RSUsed for surface dressing treatment, penetration macadam and tack coat.Medium Settings MS Used mainly for premix work with aggregate. Also can be used for tack coat and surface dressing where quick breaking of the emulsion is not required.Slow Setting Used for plant or road mixes with graded and fine aggregates. Instructions for Use Of Bitumen Emulsion:- UNIVERSAL Cationic Emulsions are fluid enough to be applied at normal temperature. The Emulsions are chocolate in colour but after emulsion has broken, the colour changes to black. The traffic should be kept off for as long as possible after rolling or at least until it is clear that the emulsion has broken.Do not heat the Bitumen EmulsionDo not let the Emulsion to freeze. UNIVERSAL Cationic Emulsion:- Characteristics Type of Emulsion RS MS SS Residue on 600-micron IS Sieve (Percent by mass, Max) 0.05 0.05 0.05 Binder content Min, Percentage by mass 57 57 57 Viscosity by Saybolt Furol Viscometer, seconds At 25 C At 50 C --- 50 - 400 --- 50 - 400 20 - 100 --- Coagulation of emulsion at low temperature Nil Nil Nil Storage stability after 24h, Percentage 1 1 1 Particle Charge Positive Positive Positive Stability to mixing with coarse aggregate (Percentage coagulation) 20 - 80 < 40 < 5 Stability to mixing with cement (Percent coagulation) --- --- <2 Miscibility with water Nil Nil Nil Tests on residue:- Residue by evaporation minimum percentagePenetration 25 C/100g/5secDuctility 27 C/cmSolubility:-In carbondisulphideIn trichloroethylene 57 60-210 100 9997.5 57 60-210 100 9997.5 57 60-210 100 9997.5 Advantages:- No machinery is required for application. No transportation cost for carrying machinery.Fuel cost is saved also manpower is also reducedBitumen Emulsions are non toxicPollution free application as no heating is requiredIt can be applied in rainy season also. Packing:- The UNIVERSAL Cationic Emulsions are available in Bulk as well as 200kg. Drums.