Baseboard Mx-lpc1114-s

These Baseboard MX-LPC1114-S has 32KB of internal flash and 8KB SRAM. The LPC1114 operate at CPU frequencies of up to 50MHz. In-System Programming (ISP) and In-Application Programming (IAP) via on-chip bootloader software. Programmable WatchDog Timer (WDT). 1 x UART,1 x I2C-bus interfaces Fast-mode Plus with a data rate of 1 Mbit/s. 1 x SSP controllers, 8-channel 10-bit ADC, Four general purpose counter/timers with a total of four capture inputs and 13 match outputs. Integrated PMU , power on Reset and up to 42 general purpose I/O pins. GPIO pins can be used as edge and level sensitive interrupt sources.

Following are the salient features of the board:
Dimensions: 126x35 mm2
Two layer PCB (FR-4 material)
On-board Test Led
12MHz crystal
On board debugger.
No power supply required, powered through USB
What tools to use?
Our products are in general not tied up to one particular tool. All the tools that support lpc11xx cortex-M0 series of micro controllers can be used, to name a few:
CooCox CoIDE (Highly recommended)
CooCox CoFlash (Highly recommended)
Keil RealView MDK 4.03 or higher a 32K code limited version could be used
IAR workbench a 32K code limited version could be used