Wire Nail Making Machine - Steel Wire, 130x100x105 Cms, Green | Automatic, Precise Design, 500 Nails/minute, Easy To Install

Nail Making Machine Process:
This equipment covers one main crank and two side shafts. Due to the special bearing design, it is smoother in operation as compared to the traditional Nail Making Machine. The main axle is directly driven by the motor. In addition, the two side shafts separately used to control the nail cutter part and nail mold part are pulled via four bevel gears.

Specifications:
Max Wire Diameter S.W.G. (m.m.) : 2.03mm - 2.65mm, 14g - 12g
Max Length : 12mm - 65mm, A " - 2.5"
Max Speed (Nails/Minutes) : 500
Power Required H.P. : 2
Case Size (cms) : 130 x 100 x 105
Automatic : Yes

A wire nail having a head and a shank integral with the head, the shank being formed with a tip and having an axis, and the head having a circumferential edge defining a complete circle; characterized in that the centre of the head is radically offset from the axis of the shank.

The wire on the wire wheel will be fed to the working center through the wire roller of the nail making machine, and then the nail head is formed via the stamping of the punch pin after the nail mold clamps the wire tightly. After loosened by the nail mold, the wire will be driven to cutting center through the side shaft. Later, the nail will be cut into the set length. Finally, the finished nails will be automatically ejected through the ejector.

Features:
Longer service life
Precise designs
Made of high grade steel and modern machinery.
Quality assured
Very low prices range.
Easy To Install.
Easy To Operate