Pollution Unit

Wet Collectors (Pollution Unit) For Drum Mix Plants
With the thermodrum mix process two types of emmisions may be encountered. particulates and "Blue Smoke".

The most efficient method of collecting sufficient quantities of these particulate emissions, for cleaner exhaust air is the wet type collector. These wet type collectors work on the principle of wetting the dust particules entrained in the exhaust gas stream and trapping them in water droplets which full out of the exhaust gas and are drained from the system in the form of waters sluge.


Dimensions
1Diameter:1630 mm .
2Length:5750 mm
3Width:1850
4Height:2455
5Total Weight:--------------

Operating Data

DM-45 PLANT
DM-50 PLANT
Capacity
ACFM
:
10500
14500
Fan
HP
:2025
Waterpump
HP
:33
Waterpump
Size
:65 x 50 mm65 x 50 mm

Water Requirements
:
CIRCULATING WATER MAKE UP
Pump Size
Pressure
GPM
SuctionPressureGPM
1A "
50
110
435

Warning
As a safety measure, always enclose or cover setting tank with wire fencing as water temprature during operation is approximately 150A F

The Setting pond shown is divided into three section by weires. The Sludge from the separator enters section (A) Where much of the sludge settles out before flowing over into section (B) By the water enters section (C) It is amply clarified for rearculation.

Minimum Sludge Pond Requirements
Length
Width
Depth
GPMGallonsArea Sq. Ft.Volume Cu. Ft.
38'
19'
6'
11033,