Pressure filters can apply a large pressure differential across the septum to give economically rapid filtration with viscous liquids or fine solids. The most common types of pressure tilters is filter press.

A tilter press contains a set of plates designed to provide a series of chambers or compartments in which solids may collect. The plates are covered with a filter medium such as canvas cloth. Slurry is admitted to each compartment under pressure; liquor passes through the canvas cloth and out a discharge pipe, leaving a wet cake of solids behind. Plates and frames sit vertically in a metal rack, with cloth covering the face of each plate, and are squeezed tightly together by, screw. Slurry enters at one end of the assembly of plates and frame. It passes through a channel running lengthwise through one corner of assembly.

The set up consists of 7 plates and 6 frames. Frames are covered with filter cloth. Feed is fed b gear pump at the top and filtrate collected at the bottom from each plate by operating the cock. After removing Cake, washing and cleaning can be done by water provided by overhead tank. Inlet & outlet pressures are measured by pressure gauges. Rate of filtrate removals is measure by calibrated tank provided.

Range of EXPERIMENTS

To study the operation of filter press in the laboratory

To evaluate specific cake resistance and medium resistance

UTILITIES REQUIRED

Electricity 1 kW, 220 V, 1 Phase

Water supply & Drain

Slurry required to perform experiment

TECHNICAL specifications