Modbus Tcp / Rtu Enabled Eth I/o

This is a Device that is used for checking input status and controlling the devices, which are attached to ETH I/O over Modbus TCP or Modbus RTU protocol. It enables remote gauging, managing and control of Device through the network based on Ethernet and TCP/IP or through RS232. The ETH I/O is available in 2 models. One is ETH I/O 1208 and ETH I/O 0505. This capability brings the advantages of remote management and accessibility to other devices over the network.
The ETH I/O 1208 is the most cost effective monitoring and controlling device. The ETH I/O 1208 is having 12 relay outputs, 8 optically isolated inputs and 2 analog inputs. The ETH I/O 0505 is having 5 relay outputs, 5 optically isolated inputs. Both the models supports Modbus TCP for network communication and Modbus RTU for RS232 serial communication.
Specification:
* Processor Used : HCS12 Core
* Program Memory-Internal : FLASH 64K
* Network Interface : Ethernet 10Base-T or 100Base-TXConnector
* Serial RS-232 Signal : TX, RX,GND, RTS, CTS, Only
* Serial Baud Rate : 9600bps
* Data parameters : 8 Bits, No parity,1 Stop bit
* Flow Control : NONE
* Protocol Supported : TCP, IP, ARP, ICMP, Telnet
* Environment : Operating: 5 to 50 Deg C
* Number of Socket Connections : 4 Passive or Active only.
* Serial and LAN BUFFER : Enable / Disable
* Device Configuration : Serial/ Telnet
* Firmware Version : Upgradeable through Flash
* Input : Optically isolated Digital inputs. Can take in Voltages from 5 V to 24V DC