Laser Cutting Work - Acrylic, Wood, Mdf & Plywood Up To 1 1/4 Inch Thick | Dual Head Design, High Air-flow Frost Edge Feature, Superior Power/speed Control For Precision

Acrylic cutting: Max cutting of acrylic is 3/4 inch (18mm) in one pass using 100W laser and 11/4 inch (31mm) using 200W laser. High air-flow can result a frost edge while preventing from flaming. For thin material, dual head is a good decision for increasing the production volume.Modeling: Thin acrylics, mat-board and wood are materials of choice. Vector cutting and scoring from CAD software are very common. Our unique feature of power/speed control is much better than other machines. And it is critical for architectural customers.Plastics cutting: Aside from the very thin (less than .030") do not bother cutting polycarbonates (lexan). The edges will always be brown/yellow, and it produces hydrochloric acid during the cutting, which will eat up everything inside the laser and in the exhaust system. This is the same problem with PVC. ABS seems to work fine, as does polyesterWood / MDF /Plywood: About the thickest wood, the 100W can cut 3/4 inch and 200W can cut1 1/4 inch depending on the wood. 100W is ideal for cutting 6mm MDF board for decoration items. 100W has only limited capabilities to cut plywood of 3/4 inch for steel rule dies. For wider cut width, parallel cut is easier to get and control the width required. 200W can cut almost two times faster than 100W. The cuts are not straight enough unless power is sufficient.Wood / MDF /Plywood: About the thickest wood, the 100W can cut 3/4 inch and 200W can cut1 1/4 inch depending on the wood. 100W is ideal for cutting 6mm