Jet Mill By Varahi Engineers And Fabricators

Operating pressure in between 7-8kg/cm2
Average feed size of materials is 200 mesh
Adequate quantity of air, Controlled feed and micro fine setting play an important roll.
All the data given are nominal only. It may vary widely from case to case depending upon many factors.

Use of Jet Mill:
Varahi Jet mill is to micronise Pharmaceuticals, Chemicals, Pigments, Minerals, Agrochemicals, Minerals and thermoplastics. It is also for heat sensitive, corrosive and abrasive materials.
About Jet Mill:
Micronizing as well as classification is to be done in Varahi JetMill by taking advantage of fluid energy. Mill is designed to inject high pressure Air or Steam in to cylindrical chamber through Specially designed Nozzle. Nozzles are placed at equally spaced on peripheral wall to have each Jet is tangential at imaginary smaller circumference. Venturi system is control fed rate of material very precisely to get productivity. Jets are generate high velocity vortex during material feeding which create vacuum to suck product into high speed vortex. Suspended partial of the material are collide with each other and reduce themselves by attrition as well as collision whenever it comes in strong velocity gradients near the jet. Micronised partials are get out with jet fluid through center of chamber and get collected into the cyclone collector system. Heavier or oversize partials are stay in to chamber until micronized due to Centrifugal force.