Gravity Feed Spray Gun - High-precision Engineering, Optimal Air Pressure Adjustments For Continuous Production

The Gravity Feed Spray Gun has been finely engineering to provide with the finest result and the continuous production capability that you desire. To derive full benefits from the feature of the gun please follow the instruction given here :

Air Supply to Gun :
Ensure that the air supply is sufficient in volume (cfm) and pressure (psi) and is feel from oil, moisture and dust. Use a air filter cum regulator for best result.

Paint Supply :
The paint or the liquid being sprayed is to be used at the viscosity recommended by the manufacturer. Use the correct thinner to adjust viscosity. The paint container (gravity feed cup) is to be cleaned well before filling with paint.

Air Hose :
The air hose has to be of the correct diameter and should be resistant to solvents.

Installation and commissioning :
Ensure that the correct air cap and fluid nozzle combination is chosen on the gun. use the selection chart given below for guidance. Attach the air supply line to the air Intel. An sir transformer installed as close as possible to the gun will provide filtered and regulated air.
Mix, prepare and strain the material to be sprayed according to the paint manufacturer instructions.

1. Fill the gravity feed sup with the material. Do not overfill. Make sure that the vent hole in the cup lid is clear.
2. Adjust the atomisation air pressure to 35 psi.
3. open the spreader adjustment valve by turning the valve stem auto- clockwise.
4. Close the fluid needle adj