Dow Corning By Sterling Polychem

With having rich experience we are offering Dow Corning one-part moisture cure adhesives are generally cured at room temperature and in an environment of 30 to 80 percent relative humidity eliminating the need for curing ovens and the associated costs of energy and capital. Greater than 90 percent of full physical properties should be attained within 24 to 72 hours and varies according to product. Faster manufacturing throughput is achieve however since the adhesive and component can be handled in much shorter times of about 10 to 120 minutes depending on the adhesive selected and the amount of applied. These adhesives are not typically used in highly confined spaces or where a deep section cure is required as they generally cure from the exposed surface inward at a rate of 0.25 inch per seven days. Cure progresses from the outer exposed surface and is dependent on the moisture in the air. Working time is generally a few minutes to an hour for these products until a surface skin begins to form. Mild heat below 60A C (140A F) may be used to increase through-put by accelerating the cure.

FEATURES
a c No corrosive cure by-products a c Low volatility a c UL 94V-0
BENEFITS
a c One part for easy and fast dispensing a c Fast skin-over time for quick handling and reduced cycle time a c Neutral cure for use around all electrical and electronic devices
POTENTIAL USES
a c Component fixing and attaching a c Device sealing
APPLICATION METHODS
a c Manual or automated needle dispense