Desoldering Station - E300 Model | Precision Solder Pump, Multi-pin Component De-soldering, Quick Release Solder Dross Clean-up

Desoldering Station is designed for de-soldering the through-hole component on PCB.

Taking off the multi-pin through-hole component from the board is quite difficult. If you do not take care of the taking off process, it is very easy to damage the through-hole soldering pin and the conductive through-hole wall.
E300 is designed for solving this problem, helping take off the through-hole component safely and easily especially to the multi-lead-pin component and heavy thermal capacity component.
Put the board on the board holder, select the right solder nuzzle, alight it to the target component pin, start the solder pump, the solder will raise to the through-hole lead pin. In one wave programmed, the component is de-soldered in couple of seconds. Then, you can take off it safely and easily. After that, you can use the air nuzzle pressing the board from above and blow off the solder dross making the through-hole in neatness.