Demister Pad - Mesh Pad Type With Semi-permanent Material, 99% Efficiency, Self-cleaning Capability, Easy Installation, Versatile Use In Vacuum Towers And Knockout Drums

These Demister Pad should be horizontally fixed and supported. At the bottom or both the top and the bottom, a support grid which is welded with 25X3t, RB6A of the same material as that of the demister pad at proper intervals (APP150mm), is used. For fixing the grid and the pad, RB6A or 1.6A tie wire is used. The way of fixing is as per the below figure.
2.DEMISTER FEATURES (Mesh Pad type)
1. It shows 99% efficiency under general conditions and velocity (1~3m/sec or higher).
2. Over 98% open area is guaranteed under any conditions so pressure drop caused by the use of the demister can be disregarded (0.1a ~1.0 W/G).
3. It can be made of any material suitable for the given temperature and corrosion-resistance.
4. It is possible to install by use of M/H so it is easy to handle.
5. There is no restriction in the conditions, place, and size for use. It is installable on the existing systems.
6. Self-cleaning is possible. It is semi-permanent so it is economical.

3.USE OF DEMISTER
1.Vacuum Tower - The treatment quantity by the demister goes up by 35%. The quality of oil gas is improved.
2. Absorber - Some gasoline plants use a glycol absorber (Demister mounted) so the installation cost is being repaid within a month.
3. Knockout Drums and Separators - If Demister is used, a inch drum is sufficient.
4. Gas Separator Vessels - Hydrocarbon in gases is collected so gas of 1/0.1 billion purity is produced out.
5. Evaporator - Product loss goes down