Sika Grout 214 In - Product Type: Bag

370.0 INR (Approx.)

60 INR (Approx.)

225.0 INR (Approx.)

Dual shrinkage compensated Suitable for temperature of above 0 C up to +200 C Easy to mix, only add water Adjustable consistency Very good flow characteristics Rapid strength development Excellent bond to concrete No segregation or bleeding High final strengths Initial expansion by gas generation Impact and vibration resistant Non-corrosive to anchor bolts, base plate / saddle / frame, sliding plate Not harmful to concrete and reinforcing steel Not flammable Non-toxic Frost, oil and fire resistant Require normal curing Suitable to use under restraints and grout thickness required Expansive to counteract initial shrinkage Maximum flow distance is compatible to the dimensions of base plate / saddle / frame Resistant to the chemicals, gases etc. being handled in equipment Chloride free

Surfaces shall be clean, dry, free of any loose or friable particles, contaminants such as dust, dirt, oil, wax, polish grease, cement laitance or efflorescence. Use adequate preparation techniques to remove all traces of any materials that could reduce the product's adhesion to the substrate. Smooth surfaces should be roughened lightly to improve adhesion. To confirm adequate surface preparation and coating adhesion, carry out a small trial before full application. Any small surface defects and variations in level, profile, or around exposed aggregates can be prefilled and levelled with an additional layer of SikaCeram - 50 Tilofix to a maximum thickness of 5 mm, applied at least 24 hrs before full adhesive application. For larger and thicker areas of surface reprofiling and making good, use appropriate mortars from the Sika MonoTop or SikaCeram Floor Leveler range. Identify cracks in substrates and seal appropriately with Sikadur epoxy resins. For applications in hot climates / environments, or on absorbent substrates, thoroughly pre-dampen the surface immediately prior to product application. Avoid any ponding / standing water on the surface. Surface must not be damp to touch. If a waterproofing layer is required, cement-based and acrylic-based Sika waterproofing product / system must be applied to the substrate before tiling.

Dmax: 2.36 mm

0.5 N/mm2

ASTM C1107

Bonding the following types of tiles for floor and wall: Ceramic Earthenware Bonding the following types of tiles for floor: Vitrified

30 Kg Bag

20 kg , 40 kg

Flexural strength Curing time Flexural strength 7 days ~9 N/mm2 28 days ~10 N/mm2

Other, Waterproofing Coating

Cash Advance (CA), Cash in Advance (CID)

Cash in Advance (CID)

Cash Advance (CA), Cash in Advance (CID)

2 Days

7 Days

2 Days

Bihar, Jharkhand, Odisha, East India, West Bengal

All India

Jharkhand, Odisha, West Bengal, East India, Bihar