Process Weight Indicators

We offer a wide range of Weight Indicators. It is highly versatile, accurate and different from the conventional indicators. It displays analog signal (mV) input from the Load cell into engineering values. With the help of the keypad and display, unit allows to set and modify various configuration parameters and calibration.

General Specifications of this unit are:

On board 24-bit ADC is provided for Digitizing Analog Input.
Filtering: Analog & Digital
Sampling speed: 15 readings/second
Power Supply: 24 VDC
Input: 4-wire Load cell, Up to Four Single Load cell with 300 Ohms Resistor
Remote input for GROSS/NET, TARE and Zero functions
Display: 5-digit 7-segment 0.56a Red LED
Decimal position: Selectable.
Key board: Four keys membrane like
Programmable Parameters:
Decimal Point, Capacity, Display Resolution, Grad, Zero Track Band, Zero Range
Configuration Data are stored in serial NVRAM, Battery back up not required
Calibration through software (Offset:a Za & Span: a Sa stored in NVRAM)
Optional:
Serial Port for communication with the remote display/Printer/Computer using RS-485/RS-232
Outputs:
One Digital output (opto isolator)
Retransmission: 4-20 mA/0-10V Proportional indicated weight
Two Control Relay
Enclosure: Plastic, General Purpose, Panel Mounting type
Dimension:
oOuter: 96 mm (W) x 48 mm (H) x 110 mm (D)
oCut-out: 92 mm (W) x 44 mm (H)