Automatic Water Level Controller By M.g.r. Technologies

Banking on the skills of our qualified team of professionals, we are instrumental in manufacturing and offering a supreme quality range of Automatic Water Level Controller in Bengaluru, Karnataka, India. Product Details: Input Voltage: AC 230 Volts Relay Contact Eating: One N/O Potential free contact rated at 10Amps at 230 Volts Trip Time Delay: 65 Seconds in case of priming fault Motor Trips if voltage Greater than 250 or Less than 160A C Dimension: 230 x 150 x 63 (LxBxH) Working Voltage: 45 Second even in Voltage Frequency: 50 Hz Brand: MGR Power Consumption: 2.5 Walts (approx.) LIAMOCON switches on the motor if: The water in overhead tank falls to prefixed low level i.e., below 75%, 50%, 25% as adjusted. The sump is full irrespective of any levels in the over head tank at once when power comes Soft touch NEED in case to Switch on the motor in any irrespective of any level in the over head tank The switch is in manual position LIAMOCON switches off the motor for the following reasons: Liquid reaches maximum level in the over head tank There is a low or high voltage Liquid in the sump goes below foot valve or as prefixed low level Liquid does not flowing to the over head tank The switch is in off position Fuse blown off Front Facia of Liamocon: Show clear indication of water levels in the over head tank and sump tank Shows voltage variation if any in the left bottom corner, it shows green indicator for normal voltage, higher red light indicates high voltage and lower red light indicates low voltage Has an easy operate able AUTO MANUAL feather switch Green indicates AUTO Mode, Orange indicates dry running of motor Soft touch 'NEED' in case to switch on the motor irrespective of any level in the overhead tank Soft touch 'SILENCE' for silencing alarm Blinking green light indicates liquid flow to overhead tank Red indication with beeping sound for over flowing of water from over head tank Side leap switch enables to power on and off Direct on for motor Gives Alarm: When there is a voltage fluctuation When the motor is dry running due to footvalve blockage or priming fault in motor When water overflows from the overhead tank at 'MANUAL' Mode> Applications: Automatic water level Controller for hotels, Factories, Homes, Apartments, Commercial Complexes, Drainage, etc It can be fixed for single phase motor, single phase Submersibles, Three phase motors. (For three phase and Single phase Submersible Starter is necessary) and open well, Bore well, Sump. We can control two motor & two sumps & two over head tanks by a single unit (Auto Change Over). Many models available different range Available Models: Wireless Two / Three / up to 6 tank Controller Timer with Auto Controller Auto Changeover with Single System between Sump and Bore well Customized Designs