टाइल चिपकने वाला

4

3

Industrial

Wall, Floor

1. Power should be applied with a suitable toothed spreader, to be chosen according to the size andcharacteristics of the rear surface of the tiles. It is best to use the smooth part of the trowel to spreada fine initial layer, pressing down hard so as to obtain maximum adhesion to the substrate and toregulate water absorption, after which the thickness can be adjusted as required by tilting thespreader at an angle.2. Spread the adhesive over a surface area which will allow for laying of the covering materials within the indicated open time, and check for suitability of the adhesive at regular intervals. The open time may vary considerably even during the application, depending on various factors such as exposure to sunlight, air currents, absorbency of the substrate, temperature and relative humidity of the atmosphere.3. Press down each tile to allow for complete, uniform contact with the adhesive. In the case of laying in environments subject to heavy traffic, in outdoor locations, on underfloor heating systems or with materials4. In general, ceramic tiles do not require preliminary treatment, however these materials should be checked to ensure they are free from traces of residual dust or materials not properly anchored to the surface.

सफ़ेद

7 दिन

5-10 दिन

As per Requirment हफ़्ता

1

1

एक निश्चित मूल्य सीमा के भीतर, मुफ्त नमूने उपलब्ध हैं

यदि आदेश की पुष्टि हो जाती है तो हम नमूना लागत की प्रतिपूर्ति करेंगे