Pipe With Rubber Seal Socket

On completing the installation of the pipeline, Pipe with rubber seal socket must be tested for leakage by applying and maintaining pressure for the whole system within a fixed time.
Slowly filling up the pipeline with water, starting at the lowest point, thus avoiding hydraulic power bump and removing all air.
- Testing time: At least one hour, but not exceed 24 hours.
-Testing temperature: The ambient environment temperature.
- The test is done on each section 500 meters of maximum length.
- All intermediate control valves shall be opened at full size throughout the duration of the test.
Chemical resistance.
Under high impact strength and hydrostatic pressure
Its specific gravity is one fifth of the steel pipes with the same size.
Simple and quick installation.
Non toxic
Small friction coefficient.
Good insulation.
Low cost.
Smooth surface both inside and outside.
Easy transport.