Poly Kote

  Poly KoteMAKPOLYKOTE  4MM  PRODUCT DESCRIPTION MAKPOLYKOTE 4MM is an Anti Corrosive tape based on Bitumen and specifically designed to comply with the requirements of IS:10221-1982  It incorporates a centre core of 45 gsm/sqm of Fibre Glass Tissue  and  HMHDPE film  of 20 micron which lends mechanical strength, dimensional stability to the product. These centre cores are laminated with 3 layers of bitumen mix. The final product  has a top and bottom layer of thermofusible HMHDPE Film.  All the seven layers are calendered together to create this revolutionary 4mm thick tape.  APPLICATION PROCESS Application procedure is as follows : Wire brush the Pipe to remove all foreign debris.Apply a coat of Primer @ 200 gms/sqm and allow it to dry till it becomes tacky.MAKPOLY KOTE   4mm   is   then  wound  around  the  Pipe  in spiral  fashion  and  bonded    to  pipe   by   thermofusion    process  using  LPG Torch..    An    overlap  of   10mm   is  to  be   allowed.   The       overlaps  are  to  be sealed  by thermofusion process.An area of 250 mm at the end of the Pipes is to be left uncoated to permit installation and welding. This area is to be coated after welding.   MAKPOLYKOTE  2MM PRODUCT DESCRIPTION MAKPOLYKOTE 2 MM is an Anti Corrosive tape based on  Bitumen and specifically designed to comply with the requirements of   IS:10221-1982  It incorporates a centre core of 45 gsm/sqm of Fibre Glass Tissue  and  HMHDPE film  of 20 micron which lends mechanical strength, dimensional stability to the product. These centre cores are laminated with 3 layers of bitumen mix. The final product has a top and bottom layer of thermofusible HMHDPE Film.  All the seven layers are calendered together to create this revolutionary 2mm thick tape. APPLICATION PROCESSApplication procedure is as follows : Wire brush the Pipe to remove all foreign debris.Apply a coat of Primer @ 200 gms/sqm and allow it to dry till it becomes tacky.MAKPOLY KOTE   2mm   is   then  wound  around  the  Pipe  in spiral  fashion  and  bonded  to  pipe    by    thermofusion    process  using  LPG Torch..    An    overlap  of   10mm   is     to  be  allowed.   The  overlaps  are  to  be sealed  by thermofusion process. A second coat of primer is applied over the first layer of MAKPOLYKOTE 2 mm and allowed to Dry till it becomes tackyMAKPOLYKOTE 2mm second layer is spirally wound over the first layer in spiral fashion and the overlaps are thermofused. An area of 250 mm at the end of the Pipes is to be left uncoated to permit installation and welding. This area is to be coated after welding.