Roof Forming Machine By Rapid Machine Mfg

This machine is full-automatically controlled by PLC,the whole hydraulic transmission, drive hydraulic oil jar carry out and shear through centre pump station toward the hole, hydraulic pressure motor trans-mitt power as main transmission, characteristic its reliable for to operate steadily by hydraulicprdssure,Shear towards hole precision high, high output, low energy consumption, Section geometry form rule of the notch, Its hydraulic pressure transmission ,two sets of rectification correct and fit, the cut-off have a national patent.

Main motor power:30KW
Roll stand:16
Thickness:1.5-3.0mm
Material of cutter:Cr12
Spec:140-300
Waist height:50-90


The C-shaped or Z shape purlins formed by purling forming machine have excellent anti-bending property and are easy to install. They are widely used as the supporter of roof and wall in large-scale and mid-scale construction, such as factory, warehouse, garage, exhibition center, cinema, theatre, garden and so on.

Machine components: One Purlin Forming Machine can produce many sizes of purlin. Purlin forming machine mainly consists of uncoiler, coil sheet guiding device, flattening device, roll forming system, punching equipment, cutting equipment, hydraulic station, PLC controlling system and support table.

Suitable Material: Cold-rolled steel strip and heat-treated galvanized steel strip;
Forming speed: about 10-12m/Min
Power Requirement Main motor power: 15 Kw(Depend on final design)