Hydraulic Multi-station Busbar Processing Machine (Jpmx-303c)

We are engaged in offering excellent quality Hydraulic Multi-Station Busbar Processing Machine (JPMX-303C) to our valuable clients. The hydraulic multi-station busbar processing machine is mainly used for different types of processing of copper or aluminum busbar.It is easy to operate and high production efficiency. So it is an ideal processing equipment for electrical appliance manufacture of high and low voltage. There are four foot-wheels to move easily.

It has three units :punching, shearing and bending
Punching unit:1.Punching unit uses the square integral structure, make sure the upper die and the lower die are absolutely in the center.
2.Can punch different holes by replacing the dies
3.Three location modes: locating pin,caliper and light.
4.No pressing mark on the workpiece surface.
5.Can punching non-standard holes,for example, square hole, oval hole,etc
6.2 limit switches

Shearing unit: 1.use sharp shearing. flat incision interface, no droop and burrs and waste.
2.Two pressure plates to make sure no apex angle.
3. 2 limit switches

Bending unit: 1.2 sets of bending dies.
2. Horizental bending.(2 sets bending dies)
3.Vertical bending( 2 sets bending dies)
4.2 sets of embossing dies

Clients can avail this Hydraulic Multi-Station Busbar Processing Machine (JPMX-303C) at industry leading prices from us.