Kemclean (Soak Cleaner)

Product Specifications

Product Operating Data

Product Operating Procedure

By Immersion Applications
The components which are to be cleaned should be first of all dipped into kemclean-S-1 tank at a room temperature only.

Dip time: 10 minute

After cleaning the components in Kemclean-S-1 chemical, they should be thoroughly rinsed with cold water by spray. If the rinsing tank is used by immersion, an agitation is must in the cold rinsing tank, in order to obtain best cleaning. The water rinsing tanks should always be over flowed continuously in order to avoid the excess contamination in the rinsing tank.

By Brush Applications
The second method is by brush application method. The components should be wiped out with rags or by brush (with our Kemclean-S-1) cleaner and leave the components for 5 minutes and finally rinsed with cold water to remove this emulsion cleaner.

Product Application Equipment
Kemclean-S-1 tank should be fabricated with 3 - 4 mm thick M.S. With continuous with fresh Kemclean-S-1 chemical only.

Testing and Control Procedure
No chemical test is required. Kemclean-S-1 is consumed by drag out only and thus can be maintained with fresh Kemclean-S-1 chemical only.

Chemical Replenishment
The Kemclean-S- tank never be discarded. After considerable time when the contamination i.e. like oil, soil float on the tank then Kemclean-S-1 solution should be transferred to the next rinsing tank and allow the chemical to settle down overnight. Then on the next day again filter Kemclean-S-1 in the first soak cleaner tank and maintained the level of the tank by adding fresh kemclean-S-1 chemical in the tank and start the production.

Safety Measures
Kemclean-S-1 is a solvent base material and is therefore inflammable. Smoking and naked flames should be avoided in the vicinity of the cleaning tank. The most important factor is that water should be mixed, which will reduce effect the efficiency of the Kemclean-S-1 solution.

General Information
Cover process tank when not in use.