Textile Grade Starch

ANILOBOND - CG
(Modified Starch-Cold Process Corrugation Gum Powder)ANILOBOND-CG is an adhesive product specially formulated for use
in corrugated board manufactured by DSIR recognised in-house R & D
facilities of ANIL PRODUCTS LTD.
Conventional adhesives used in corrugated board manufacture have
several disadvantages. To maintain viscosities at convenient levels the
high water levels cause problems. If, on the other hand, the water
level is kept low and viscosity increased, proper penetration into the
paper is inhibited.ANILOBOND-CG offers a cure to the paper converters problems such
as weak bonding, reduced machine speed, wash boarding, adhesive waste,
etc. ANILBOND-CG is formulated on the principle of the commonly used
Stein-Hall system. However, it has the advantage that both the carrier
and non-carrier starch are present in the same formulation, a no
cooking of the carrier starch is needed.ADVANTAGES: ANILOBOND-CG provides following advantages:







Has a consistent and extremely stable viscosity (15 to 20 seconds by ATIRA Cup having orifice diameter 3mm)Has good penetration into paper.Has low gelatinisation temperature for better machine runnabilityProduces strong green bond strength (also in high density paper)
which resists delaminating during the mechanical operations such as
slitting, scoring Cut off and take away.Increases pin adhesion, hence the defect of wash boarding is minimized.Better coverage with economy.Improves stress and strain tolerance of finished corrugated containers.
PEPARTION OF ANILOBOND-CG SUSPENSION AT SINGLE FACER
Flowable lump free suspensions of ANILOBOND-CG can be made by gradual
Addition of one part of ANILOBOND-CG to five parts of water previously
taken in glue tank, with proper agitation. After complete addition of
ANILOBOND-CG the suspension is stirrer for 20 minutes. The suspension
is to be stirred occasionally during storage and just also before use.CORRUGATING At single facerTEMPRATURE
The temperature of corrugating rolls, the pressure roll. and preheaters should be set at a minimum of 110oCAVAILABILITY: ANILOBOND is available in 25kg.plastic lined HDPE woven bags.