Construction Fibers - 6mm Length Application: Used In Plasters In Finishing Coat

CPP06 are polypropylene of 6 mm cut length. These micro fibers prevent crack formation and provide reinforcement. They are mainly used in plasters in finishing coat, for ornamental castings for crack prevention and as well as additional reinforcement. Suitable care has been taken to ensure dispersion of fibres during hand mixing of mortar. Suitable care has been taken to ensure dispersion of fibers in the mix. It conforms to ASTM C 1116/C 1116M a 10a 4.1.3 Type III & BS EN 14889-2:2006.

DOSAGE
Dosage: - 600 grams / cu. mtr. (minimum). The mentioned dosage is just a guideline. It is recommended to optimize the dosage depending on the requirement.

DIRECTION OF USE
For site mixing: - Add fiber in the drum after adding some water (which is added to clean the drum after each batch). Then add chips/sand/cement/water in the concrete mixer and continue normal operation.
For Manual Mixing: - The fiber is dosed in a bucket half filled with water. The water in stirred vigorously, which disperses the fiber. The water and fiber mixture is sprinkled over the other cementatious mix.
For dosing in Ready Mix Truck: - Add fibres in the rotating drum and allow extra revolutions of drum in maximum RPM possible.


SPECIFICATION

Material : Virgin PP

Length : 6.0 +/- 0.25 mm

Diameter : 24 micron (approx.)

Aspect ratio: 250 (approx.)

Melt Point: 162 OC

Specific Gravity: 0.91

Thermal & Electric : Low
Conductivity
Alkali Resistance : 100% Alkali Proof

Acid & Salt Resistance: High