Bitumen Emulsion Plant (Uvb-1 2m3/hr)

We are engaged in exporting and supplying an excellent quality Bitumen Emulsion Plant (UVB-1 2m3/hr) in Poltava, Poltavs'ka, Ukraine.
Installation bitumen grade UVB-1 is designed to produce both anionic and cationic bitumen emulsions, which are used in road construction :
for tack of the old pavement before applying them on asphalt ;
to prepare cold asphalt mixes ;
for the surface treatment of road surfaces ;
Device for thin coatings of protective layers ;
for patching roads etc.

technical characteristics
Parameter Value
1 Maximum performance (including preparation time ), 3.5 m3/hr
2 Consumption of bitumen ( penetration at 90 ... 130 ), not less than m3/hr1,5
3 Water flow m3/hr 0.6 ... 1.5 *
4 Flow breaker ( with penetration bitumen below 90 ), dm3/hr 0 ... 50 *
5 Fuel acid dm3/hr 5 ... 20 *
6 Consumption emulsifier dm3/hr 5 ... 20 *
7 Consumption of adhesive additives dm3/hr 1 ... 20 *
8 Pressure bitumen at plant inlet, max 0.2 MPa
9 pressure is applied to the mixer bitumen, 1.4 ... 1.6 MPa
10 The pressure of the aqueous phase supplied to the mixer, 0.2 MPa
11 Temperature of bitumen entering the unit, 140-160 CA
12 Temperature of the water entering the plant, 40-60 CA
13 Lift height of the emulsion after installation (m) is not more than 15
14 Installed capacity not more than 17 kW
15 voltage power circuits at 50Hz, 380
16 compressed air pressure, bar 4 ... 6
17 Airflow, dm3/min 250
18 Dimensions, mm, not more:
- length 2510
- width 1750
- Height - 1820