Bresle Salt Test Kit

The Bresle Test Kit supplies all the necessary equipment including the Bresle Test Patches, Syringes, Distilled Water, Calibration Solution and Conductivity Meter to test for soluble salt and surface contaminants on blasted surfaces in compliance with ISO 8502-6 & ISO 8502-9.

Many coatings fail due to salts such as chlorides and sulphates contaminating the surface prior to the coating application.

This contamination can be tested quickly and simply using the Bresle Test Kit.

The Bresle Patch is attached to the surface, the distilled water is injected with a syringe into the Bresle Patch and then extracted, this is repeated ten cycles of injecting and extracting the liquid in the Bresle Patch. This liquid is then measured with the Conductivity Meter will measure the quantity of salts in both ?g/cm2 (ppm) and mg/m2

Complies with ISO 8502-6, which relates to the extraction of soluble contaminants using the Bresle Patch method and ISO 8502-9, which relates to the conductometric determination of soluble salts.


The Bresle Test Kit is supplied with 50 x Bresle Patches , Conductivity Meter, Calibration Solution. 3 x 5ml Syringes, 25ml Beaker and 250ml Distilled Water.

Additional Bresle Patches can be purchased to carry out further tests using this kit.