Wind/Solar Hybrid Controller
The wind/solar hybrid controller not only can control the wind turbine and solar cell charging battery,but also has the DC output controlled by light.there is also another DC output controlled by time,
POWER CONNECTION:
I. Connect the battery's positive pole to the positive (+) of battery terminal on the controller using 6mm2 cable, and connect the battery's negative pole to the negative(-) of battery terminal on the controller using 6mm2 cable. Be sure that the polarity is connected properly! And the length of cables should be less than 1m. Then tighten the nut on each battery terminal by hand until it is snug. Do not over tighten.
II. Connect the output of wind turbine to the WIND INPUT terminals using 6mm2 cable.
III. Connect the output of solar to the SOLAR INPUT terminals, taking care of the polarity.
IV. Connect the load to the + and -1 of DC OUTPUT terminals, which is controlled by light. the load connected to the + and -2 of DC OUTPUT terminals will be controlled by time.

SPECIFICATIONS
Model WWS06-24 WWS03-24 WWS03-12 WWS02-12
Max Wind Input Power (W) 600 300 300 150
Max PV Input Power (W) 200 100 160 80
Rated Battery Voltage (DC V) 24 24 12 12
Floating Charge Voltage (DC V) 29 29 14.5 14.5
Low Battery Recovery Voltage (DC V) 27 27 14 14
Low Battery Voltage (DC V) 21.5 21.5 10.8 10.8
Low Battery Recovery Voltage (DC V) 24 24 12 12
Max.light control Output power(W) 120W 120W 120W 120W
Max.time control output power W 120W 120W 120W 120W
Protection Type Over Voltage Protection, Low Battery Protection, pole-confusion protection , automatic dump-load function.

For any further information feel free to contact us.