Applications :

Polishing is an important process for the manufacture of metallographic specimen. This equipment can be operated by two operators simultaneously. After being polished, the specimens are favored with mirror-like surfaces. The cabinet-type machine is stable running, little noise, easy operation and high efficiency. It is suitable for the metallographic labs in the factories and research institutions.
Technical Specification
Diameter of polishing plate: 200mm
Rotate speed: 1400rpm
Motor: 180W110V60HZ
Net Weight: 74kg
Dimension: 5709001100mm
Erection and Operation

Open the wooden package box and remove the four fastening bolts under the machine. Remove the tapes around the plastic guard of the polishing plate.
Put the machine on a table in a room free of dust and vibration.
Remove the plastic guard and retaining ring.

Put the wet polishing fabric on the polishing plate and put retaining ring onto the fabric so that the fabric lay flat on the plate.
Close the plastic guard.
Place a container at the water outlet to collect the waste water or pipe the waste water directly to the drainage.

Plug in the power socket and turn power on, the motor starts up and the polishing process begin.

Maintenance and Safety notice
Not to apply too much force onto the specimen to prevent the
overload of the motor or tear open of polishing fabric.
The maximum temperature of the motor is 80
The power socket shall be well grounded
The fabric shall closely contact the polishing plate. Not try to use worn fabric, otherwise the specimen may fly out during the polishing process.
Pay attention to the plastic parts when it is below -10C
Replace the high-speed lubricant after long period of operation.

Notice: The polishing fabric with contact adhesive and abrasive paper for metallographic phase can be purchased upon order.